1) Air up the factory tires to 44 psig. Place them next to the aftermarket set. 2) Get in the driver seat with the key. Press the Ignition button once without the clutch depressed to the "ON" position. 3) Push the hazard light button (6) times within 5 seconds. The horn will sound once.
Click the checkbox for "Bit 2 - Tire pressure monitoring ( TPMS /7K6) installed". Exit the long coding helper and the new code will already be under "New coding". Click "Do it!" to save and use the new code. Exit the module. When you turn on the ignition, you should see the TPMS light briefly turn on.

WNY. Hybrid Member. 151. Posted September 2, 2015 at 11:06 PM (edited) I believe there is a setting in the myview or on the display on selecting the Tire Mobility Kit service interval. 1,2,3 years, probably so the fluid fix stuff doesn't go bad to get it replaced. Not sure how long the stuff lasts if you don't use it.

Step 2 – Press down the reset button, this can usually be found under the dash or to the side of the steering wheel (check your owner’s manual if you are unsure). Step 3 – Hold the button down until the TPMS light blinks several times. Step 4 – You can now fully turn the key in the ignition and start the engine.

No need to go and buy the TPMS learning tool. 1) Make sure your tires are inflated to the recommended psi. Mine is 40psi. 2) Turn ignition to the on position. If you have a push button start, push the start button without pressing the brake pedal. 3) Push the hazard light button 6 times. Here's a quick video which shows how to reset the TPMS on a MK3 Ford Focus, as well as images providing the correct pressures for your tyres. . 99 86 411 982 35 629 167 308

ford c max 2016 tyre pressure reset